Highpoint RocketRAID 2640x4 Guía de usuario descargar pdf (Pagina 67)

Linux(Fedora,Red Hat,SuSE) Driver Support

Step 4 Configure System to Mount Volumes when Startup

Now you can inform the system to automatically mount the array by modifying the file

/etc/fstab. E.g. You can add the following line to tell the system to mount /dev/sda1 to

location /mnt/raid after startup:

/dev/sda1 /mnt/raid ext2 defaults 0 0

4 - Monitoring the Driver

Once the driver is running, you can monitor it through the Linux proc file system

support. There is a special file under /proc/scsi/rr26xx/. Through this file you can view

driver status and send control commands to the driver.

Note:The file name is the SCSI host number allocated by OS. If you have no other

SCSI cards installed, it will be 0. In the following sections, we will use x to represent

this number.

Checking Devices Status

Using the following command to show driver status:

# cat /proc/scsi/rr26xx/x

This command will show the driver version number, physical device list and logical

device list.

5 - Updating the Driver

To update the driver, simply reinstall the driver following the steps in previous

section, “ Install RR26xx Driver on an Existing System “.

Replace the driver module rr26xx.ko in the /lib/modules/[kernel-ver]/kernel/drivers/

scsi/. If the driver is loaded in initrd (e.g. when system is installed on the controller),

6-21

1 2 ... 62 63 64 65 66 67 68 69 70 71 72 ... 83 84

Sin comentarios

Highpoint RocketRAID 2640x4 Guía de usuario Pagina 67