Highpoint RocketRAID 2640x4 Guía de usuario descargar pdf (Pagina 77)

FreeBSD Driver Support

system to automatically load the driver, type in the following commands:

# echo ’rr26xx_load=”YES”’ >> /boot/defaults/loader.conf

This tells the loader to try loading the RR26xx module together with the kernel.

Now, reboot the system. RR26xx module should be automatically loaded each time

system start up.

Note: If FreeBSD you installed is 4.x version, you should type the following com-

mand to configure your system:

# mknod /dev/rr26xx c 200 0

Then, please check whether node“/dev/rr26xx”exists in /dev directory.

Step 4 Configure the System to Mount Volumes at Startup

Instruct the system to automatically mount the array by modifying the file /etc/fstab.

Example: Add the following line to instruct the system to mount /dev/da1s1e to

location /mnt/hpt after startup:

/dev/da1s1e /mnt/hpt ufs rw 0 0

4 - Updating the Driver

To update the driver with a new version you simply reinstall the driver following the

previous section, “Install the driver on an existing system”.

5 - Installing RAID Management Software

HighPoint RAID Management Software is used to configure and keep track of your

hard disks and RAID arrays attached to RR26xx controller. Installation of the manage-

ment software is optional but recommended.

To configure HighPoint RAID Management Software to work with RR26xx driver, you

should setup /etc/hptcfg to be the driver name:

# echo rr26xx > /etc/hptcfg

Please refer to HighPoint RAID Management Software documents for more

information.

7-8

1 2 ... 72 73 74 75 76 77 78 79 80 81 82 83 84

Sin comentarios

Highpoint RocketRAID 2640x4 Guía de usuario Pagina 77