Highpoint RocketRAID 3540 Guía de usuario descargar pdf (Pagina 51)

Linux Driver Support

6-4

5. Continue the installation as usual.

Installation steps for Fedora Core 2

1. Start installing Fedora Linux by booting from the installation CD.

2. On “Welcome to Fedora Linux” installation screen, a prompted label “boot:” will

appear at the bottom of the screen. Just press Enter.

3. When prompted the warning “No hard drives have been found”, press “ALT+F2”

to switch the shell on console 2. Insert the driver diskette into floppy drive and

type the following commands:

# mkdir /dd

# mount /dev/fd0 /dd

# sh /dd/fedora-install-step1.sh

# umount /dev/fd0

Then press “ALT+F1” to switch back to installation screen and select “No” to

continue.

4. Continue the installation as usual. You can refer to Fedora Linux installation

guide. Make sure you have finished the next step before system reboot.

5. When installation finishes and prompts you to reboot the system, press

“CRL+ALT+F2” to the shell and type the following commands:

# chroot /mnt/sysimage

# mount /dev/fd0 /mnt

# sh /mnt/fedora-install-step2.sh

# umount /dev/fd0

# exit

Then switch back to console 1 and finish the installation.

3 - Installing RR3540 driver on an Existing System

Note: If you use a SCSI adapter to boot your system, you must make sure the

RR3540 controller BIOS will be loaded after that adapter’s BIOS. If not, try to move

it to another PCI slot. Otherwise you may be unable to boot up your system.

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 80 81

Sin comentarios

Highpoint RocketRAID 3540 Guía de usuario Pagina 51