Highpoint RocketRAID 1640 Manual de usuario descargar pdf (Pagina 43)

4-11

Step 2:

RAID 1 Creation Option:

If RAID 1 was selected, select from the following array options (see the image below):

1) Create Only

This option will create a RAID 1 array between the selected disks, but will not preserve

any of the data. The data on both disks will be lost.

2) Create and Duplicate

This option will create a RAID 1 array between the selected disks, and will copy the

data from the Source disk, to the Mirror (also referred to as the target) disk. All data that

was originally stored on the Mirror disk will be deleted.

ATA RAID Software

Clicking on a drive icon to display information about this disk - the right side of the

screen will provide information about the physical disk, including the model, location,

transfer mode and capacity. Clicking on an array icon will provide information about

the selected array, including the name of the array, the RAID type or level, and capacity.

Creating an Array

If the Create Array option has been enabled under the Privilege settings, and enough

disks are available to create an array, click the Create button located on the toolbar.

You can also click on the Operation tab, and select the Create option. This will open

the Array Creation Wizard window.

Step 1:

Select the type of Array

Select the type of array you wish to create using the drop-down menu. If JBOD was

selected, you can jump directly to Step 4.

If any other type of array is selected, enter an array name, and click the Next button. If

you do not wish to name the array, leave the Array Name field blank, and click the Next

button.

If RAID 0, 10, or 5 was selected, proceed to step 3.

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 62 63

Sin comentarios

Highpoint RocketRAID 1640 Manual de usuario Pagina 43