Highpoint RocketRAID 1640 Manual de usuario descargar pdf (Pagina 57)

Please pay close attention to the information displayed by the BIOS - make sure all of

the hard disks attached to the controller are recognized by the BIOS.

If one or more of the hard disks are not recognized, open the computer's chassis and

check for the following:

1) Make sure the power cable for the hard drive is securely attached. If necessary, try

using another power cable.

2) Make sure the cable is securely attached to the hard disk. If necessary, try using

another cable.

After checked the above, please place the cover of computer chassis and power on

the computer.

3. Hard disk mode is not correctly recognized.

In order to boot from disk or disk array connected to adapter, usually you should do

the following:

1. Set SCSI device as the first-booting device in main board BIOS;

2. Set a booting device in RocketRAID 1640 adapter BIOS (refer Chapter 3 on how to

set a boot device).

Note: If the regular IDE hard disks are chosen, by using the RocketHead 100

converter connect to RocketRAID 1640, please make sure the hard disks jumper must

correctly set to the master position.

5-2

Trouble Shooting

1 2 ... 52 53 54 55 56 57 58 59 60 61 62 63

Sin comentarios

Highpoint RocketRAID 1640 Manual de usuario Pagina 57